Marshall DSL100 + cabinet 1960A/B - Amplificare head

The Marshall DSL 100 and 1960A 4x12 cabinet makes up this Marshall half stack. The DSL100 head is powered by (4) EL34s power tube that put out 100 watts of tube sound. The (4) ECC83 preamp tubes give you both classic and ultra gain channels where each channel has 2 modes. They can be used for anything from very clean to ultra distorted. The Deep Switch allows you to add bass frequencies to your sound which give you a monster bass. The tone shift knob scoops out the mid-range that has a similar effect but is much more drastic in that it removes the mid-range frequencies. There are two reverb controls one for each channel. On the rear panel you get the usual speaker outputs, FX loop and 2 footswitch jacks. These are for changing channels as well as turning the reverb on or off. (footswitch not included)

The Marshall 1960A is an angled 4x12 speaker cabinet that has been used by every world renowned guitarist to date. It has a well focused and loud sound. It has a very tight and full low end with a crisp and bright high end. This is what you need to have an uncluttered sound. The cabinet can be run at either 4 or 16 ohms or at 8 ohms if you are using it in stereo. It's capable of handling up to 300 watts of blood letting sound.

Specifications

Classic Gain and Ultra Gain channels,
2 modes for each input channle
Deep switch adds a resonant bass boost
Tone Shift scoops the mids
Reverb controls for each channel
2 footswitch jacks for channels and switching reverb
100W of power
4 ECC83 pre-amp tubes
4 EL34 power amp tubes
4 12" heavy-magnet drivers
Slant-front cab
4x EL34 output valves
4x ECC83 Preamp Valves
Footswitchable Accutronics Spring Reverb
FX loop
* Pentru alte combinatii de head + cabinet Marshall, va rugam sa ne contactati